Garage Door Replacement in Belton, TX

A single steel door installed in Belton typically runs $850 to $1,600, an insulated double door around $1,400 to $2,800, and premium carriage house or full view aluminium doors from $2,500 up. The quote includes new track, springs, rollers, seal and removal of the old door.

The opening is only exposed while the old door is out, usually a couple of hours mid job. We schedule so the new door goes up the same day, not on a later visit.

Always. Reusing old springs and track with a new door is a false economy, and the spring has to be matched to the new door's weight or the balance will be wrong from day one.

Look above the door at the torsion spring. If you can see a two inch gap in the coil, the spring has broken and the door is far too heavy to lift, so stop trying. If the spring looks intact, check the safety sensors near the floor for a blinking light or an obstruction, then check the opener has power. If the motor runs but the door doesn't move, the drive gear or trolley is usually the culprit.

Often, yes. If your door model is still in production we can source a matching section and swap it, which is usually far cheaper than a full replacement. On older or discontinued doors a match may not exist, and once two or more sections are damaged a new door normally works out better value. We tell you which situation you're in before you commit.

Yes. We service rolling steel curtains, sectional commercial doors, dock doors and jackshaft operators for warehouses, fleet shops, retail units and municipal buildings around Belton. Multi door sites can set up a planned maintenance schedule so problems get caught between shifts rather than during them.