Garage Door Repair in Eagle Pass, TX

Broken torsion springs by a wide margin, followed by opener drive gears and snapped lift cables. Springs are a wear part with a finite cycle count, so every door will eventually need them.

In most cases yes. Trucks carry the common spring sizes, cables, rollers, hinges, sensors and gear kits. Special order panels and some commercial parts need a return visit, and we'll tell you that on the day rather than stringing it out.

Usually worn steel rollers, dry hinges and bearings, or loose hardware that's rattling. Sometimes it's the opener rail. A tune up with nylon roller replacement makes a dramatic difference, especially with a bedroom over the garage.

Look above the door at the torsion spring. If you can see a two inch gap in the coil, the spring has broken and the door is far too heavy to lift, so stop trying. If the spring looks intact, check the safety sensors near the floor for a blinking light or an obstruction, then check the opener has power. If the motor runs but the door doesn't move, the drive gear or trolley is usually the culprit.

Often, yes. If your door model is still in production we can source a matching section and swap it, which is usually far cheaper than a full replacement. On older or discontinued doors a match may not exist, and once two or more sections are damaged a new door normally works out better value. We tell you which situation you're in before you commit.

Yes. We service rolling steel curtains, sectional commercial doors, dock doors and jackshaft operators for warehouses, fleet shops, retail units and municipal buildings around Eagle Pass. Multi door sites can set up a planned maintenance schedule so problems get caught between shifts rather than during them.