Garage Door Installation in Mathis, TX

A single door swap is typically a three to five hour job and a double door around half a day. Multi door garages are often finished in a single visit with two technicians. That includes removing and hauling away the old door.

For an attached garage or one you use as a workshop, polyurethane injected insulation is worth it. It cuts the afternoon heat noticeably and stiffens the door so it runs quieter. For a detached garage used purely for storage, a non insulated steel door is fine and cheaper.

Not necessarily. If your opener is under ten years old and rated for the weight, we'll reuse it. Heavier insulated doors sometimes need a stronger unit, and we'll tell you before you buy the door rather than after it's hanging.

Look above the door at the torsion spring. If you can see a two inch gap in the coil, the spring has broken and the door is far too heavy to lift, so stop trying. If the spring looks intact, check the safety sensors near the floor for a blinking light or an obstruction, then check the opener has power. If the motor runs but the door doesn't move, the drive gear or trolley is usually the culprit.

Often, yes. If your door model is still in production we can source a matching section and swap it, which is usually far cheaper than a full replacement. On older or discontinued doors a match may not exist, and once two or more sections are damaged a new door normally works out better value. We tell you which situation you're in before you commit.

Yes. We service rolling steel curtains, sectional commercial doors, dock doors and jackshaft operators for warehouses, fleet shops, retail units and municipal buildings around Mathis. Multi door sites can set up a planned maintenance schedule so problems get caught between shifts rather than during them.