Garage Door Cable and Off Track Repair in Rockdale, TX

It can be. The door's weight is being held by hardware that isn't designed to carry it at that angle, and running the opener can drop the door or fold a panel. Leave it where it is, keep people and cars clear, and call us.

Usually corrosion at the bottom bracket where water sits, fraying against a worn drum, or slack introduced when the door was left partly open for a long time. We replace cables in pairs and re-set both drums so the door drops evenly.

Light bowing can often be straightened and re-anchored. Kinks, flat spots and crushed sections need replacing, because a roller riding over a damaged section will keep jumping out no matter how well it's re-seated.

Look above the door at the torsion spring. If you can see a two inch gap in the coil, the spring has broken and the door is far too heavy to lift, so stop trying. If the spring looks intact, check the safety sensors near the floor for a blinking light or an obstruction, then check the opener has power. If the motor runs but the door doesn't move, the drive gear or trolley is usually the culprit.

Often, yes. If your door model is still in production we can source a matching section and swap it, which is usually far cheaper than a full replacement. On older or discontinued doors a match may not exist, and once two or more sections are damaged a new door normally works out better value. We tell you which situation you're in before you commit.

Yes. We service rolling steel curtains, sectional commercial doors, dock doors and jackshaft operators for warehouses, fleet shops, retail units and municipal buildings around Rockdale. Multi door sites can set up a planned maintenance schedule so problems get caught between shifts rather than during them.